Quick Menu
-
Miscellaneous questions
- Can the foil heater be used under tiles?
- Can the foil heater be installed under a glued wood floor ?
- Can I install my Warmup system directly on top of plywood?
- Can a wooden floating floor be installed directly over the Warmup DWS or Stickymat system?
- Why is my floor not reaching the temperature set?
-
Installation
- Where should I place the floor sensor?
- What if I damage the Foil Heater during / after installation?
- Do you need to use grounding nets with the Foil Heater?
- Can the Foil Heater be used in wet areas?
- Can I use one thermostat to control multiple Foil Heaters ?
- Can the Foil underfloor heater be cut and turned?
- Can the Foil Heater be used with Carpet or Vinyl?
- What types of Flooring can the Foil Heaters be used under?
- Can I install my Warmup system directly on top of plywood?
- Can a wooden floating floor be installed directly over the Warmup DWS or Stickymat system?
- How do I install the factory joint which is thicker than the heater wire?
- What are the electrical requirements for my Warmup system?
- Can my floor sensor be extended?
- Preparing for your project
- Troubleshooting
- Wiring
Can I use one thermostat to control multiple Foil Heaters ?
Yes, but all heaters being controlled by thermostat must be installed within the same room/zone.
Each thermostat can control up to 16 amps of heating and maximum of two heaters can be wired directly into the back of the thermostat.
If installing more than two heaters connect in parallel via a junction box.