Quick Menu
-
Installation Heater
- Is there a video guide for installing the Electric Floor Heating Mat?
- Where should I place the floor sensor?
- When can I turn my underfloor heating on?
- Should I use primer with the Loose Wire System?
- Can I use an Ditra matting with the DWS cable ?
- What type of adhesive should I use with my Warmup system?
- Can a wooden floating floor be installed directly over the Warmup DWS or Stickymat system?
- Can I cut the Electric Floor Heating System if I have too much?
- How do I install the factory joint which is thicker than the heater wire?
- Troubleshooting
- Prepare Your Project
- Electrical Installation
- Compatibility
- Wiring
Should I use primer with the Loose Wire System?
If the heating element is being laid directly onto a plywood or concrete subfloor, use the primer supplied. Leave to dry for 2-3 hours until tacky, then lay the heating element. If an insulated or standard tile backer board is being used, no primer is needed. We recommend you use Warmup Insulation Boards.