3iE Energy-Monitoring Thermostat


Home / Thermostats / 3iE Energy-Monitoring Thermostat

What Does Heater Error mean on the 3iE thermostat?

 

There are a number of reasons why the “Heater error” message is displayed:

  • A contactor (external relay ) has been fitted

The thermostat will display this error as the current sensor cannot detect a heater(s). The 3iE will still operate as normal but will constantly display the error.

  • The 3iE has been wired up incorrectly 

An electrician will need to check that the underfloor heating system has been wired into the correct terminals on the back of the 3iE.

  • There is a fault with the underfloor heating system 

If the electrician has confirmed that the system has been wired up correctly,have them test the resistance of your heating system. The resistance reading is based on the heater model installed in your floor                     using a digital multi meter set to a 200 ohms scale.

3iE Control

Additionally you can try to reset the thermostat by loosening the two screws on the bottom and pulling the face of the thermostat unit off. Then, using a small screw driver or other pointed object, you can press the reset button on the back of the face. Once you have pressed the reset button, you can put the face of the unit back on and tighten the screws.

For further assistance, please contact the Warmup support with your testing results.