Quick Menu

• Installation Heater
  • Is there a video guide for installing the Electric Floor Heating Mat?
  • Where should I place the floor sensor?
  • When can I turn my underfloor heating on?
  • Should I use primer with the Loose Wire System?
  • Can I use an Ditra matting with the DWS cable ?
  • What type of adhesive should I use with my Warmup system?
  • Can a wooden floating floor be installed directly over the Warmup DWS or Stickymat system?
  • Can I cut the Electric Floor Heating System if I have too much?
  • How do I install the factory joint which is thicker than the heater wire?
• Troubleshooting
  • What can I do if the heater is too big for my area?
  • What if I damage the Loose Wire Heater during / after installation?
  • Why is my floor not reaching the temperature set?
  • Why is my floor not heating but there are no error messages?
  • My thermostat says system is on but the floor is not heating up?
• Prepare Your Project
  • Can I use the Warmup Loose Wire System as a primary heat source?
  • Can I install my Warmup system directly on top of plywood?
• Electrical Installation 
  • Can more than one Loose Wire System be controlled by the same thermostat?
  • Can I connect one Warmup heater to another in series?
  • What are the electrical requirements for my Warmup system?
• Compatibility
  • Can I use the Loose Wire System with floor coverings other than tiles?
• Wiring
  • Can my floor sensor be extended?